The initial setup menu 16 – Pioneer DVR-LX60D User Manual
Page 138
The Initial Setup menu
16
138
En
HDMI Output
(only available when an HDMI device is connected)
Screen Resolution
1920 x 1080p
Constant 1920 x 1080p output.
1920 x 1080i
Constant 1920 x 1080i output.
1280 x 720p
Constant 1280 x 720p output.
720 x 576p
(720 x 480p)
Constant 720 x 576p output (when setting the
Input
Line System
to
525 System
, video is output in 720 x
480p).
720 x 576i
(720 x 480i)
Constant 720 x 576i output (when setting the
Input
Line System
to
525 System
, video is output in 720 x
480i).
• If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this
case, press
OPEN/CLOSE
while holding down the
(Stop) button on the front panel to switch the setting (this
also switches Component Video Out
on page 131
to the default setting).
• If you have the
Colour
set to
YCbCr 4:2:2
, you cannot select
720 x 576i (720 x 480i)
.
4:3 Video Output
Full
Select if your HDMI TV allows you to change the
aspect ratio.
Normal
Select if your HDMI TV does not allow you to change
the aspect ratio. 4:3 video will be shown with bars on
each side.
Colour
RGB (0–255)
Use if colours are weak and black appears to ‘float’
on the
RGB (16–235)
setting.
RGB (16–235)
Use this setting if colours appear overly rich and the
black too deep on the
RGB (0–255)
setting.
YCbCr 4:2:2
The video signal is output as a 10-bit YCbCr 4:2:2
component signal. This is the standard setting for
HDMI-compatible devices.
YCbCr 4:4:4
The video signal is output as a 8-bit YCbCr 4:4:4
component signal.
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the
YCbCr 4:2:2
and
YCbCr 4:4:4
options are not available.
• You cannot choose
YCbCr 4:2:2
when the
Screen Resolution
is set to
720 x 576i (720 x 480i)
.
Audio Output
Auto •
Dolby Digital, MPEG and DTS sources are output as
a bitstream signal. However, depending on the
Audio Out
setting, number of audio channels, and
the HDMI-connected device, Linear PCM audio may
be output.
PCM
All audio signals are converted to Linear PCM
(except DTS).
Bitstream Priority
Select if the connected device is compatible with
bitstream audio.
This setting is not available when a DVI device is connected
.
Setting
Options
Explanation
DVRLX60D_WV_EN.book 138 ページ ２００７年３月２６日 月曜日 午後１２時１６分