Setting up the meeting password, Using the meeting password – Polycom Webcam User Manual
Page 200
ViewStation EX User Guide
198
www.polycom.com
Setting Up the Meeting Password
To set the Meeting Password as your multipoint conference
password:
1.
From the main screen, select System Info > User Setup (or
System Info > Admin Setup > Security)
.
2.
In the User Setup screen, under Meeting Password, enter your
password.
Your configured Meeting Password is automatically and
transparently sent as the multipoint conference password to the
multipoint conference.
Using the Meeting Password
The Meeting Password can be used for the following purposes:
❑
To provide dial-in protection for the ViewStation EX MCU. If
dial-in password protection has been set on the MCU, all the
sites dialing into that MCU need to provide a password in order
to join the videoconference. Refer to
Protection in Multipoint Dial-In Calls on page 199
.
❑
To be able to dial into an MCU or a bridge that has a password
set (see above item). The site calling into the MCU needs to send
the established Meeting Password to the MCU.
❑
To view slides on the Web interface. Refer to
.
❑
To view a meeting/stream on the Web interface. Refer to
❑
To access Closed Caption on the Web interface. Refer to