Polycom SpectraLink NetLink E340 - Manual (Page 51)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Cisco CallManager and IP Phone 7960 Emulation
72-1082-02-G.doc Page 51
12.3 NetLink Wireless Telephone Status Messages
NetLink Wireless Telephone status messages provide information about the NetLink
e340/i640 Wireless Telephone's communication with the AP and host telephone
system. The following table summarizes the status messages, in alphabetical order.
Message Description Action
3 chirps Handset is not able to communicate with the
best AP, probably because that AP has no
bandwidth available.
None. This is only a warning, the call will
handoff to the best AP once it becomes
available.
Address Mismatch Handset software download files are
incorrect or corrupted
Download new software from the
SpectraLink site per Software
Maintenance .
ASSERTxxx.c
Line yyy
The handset has detected a fault from which
it cannot recover.
Record the error code so it can be
reported.
Turn the handset off then on again.
If error persists, try registering a different
handset to this telephone port.
If error still persists, contact Avaya
Technical Support and report the error.
Assoc Failed
xxxxxxxxxxxx
x…x = AP MAC address
Handset association was refused by AP;
displays MAC of failing AP.
Check handset and AP security settings.
Ensure AP is configured per Configuration
Guide .
Try another AP.
Assoc Timeout
xxxxxxxxxxxx
x…x = AP MAC address
Handset did not receive association
response from AP; displays MAC of failing AP
Check handset and AP security settings.
Ensure AP is configured per Configuration
Guide .
Try another AP.
Auth Failed xxxxxxxxxxxx x…x = AP MAC address
Handset authentication was refused by AP;
displays MAC of failing AP
Check handset and AP security settings.
Ensure AP is configured per Configuration
Guide .
Try another AP.
Auth Timeout
xxxxxxxxxxxx
x…x = AP MAC address
Handset did not receive authentication
response from AP; displays MAC of failing AP
Check handset and AP security settings.
Ensure AP is configured per Configuration
Guide .
Try another AP.
Bad Code Type xx
Expected Code Type yy
xx, yy = software licence types Handset
software does not match current handset
license selection
Download new software from the
SpectraLink site per Software
Maintenance .
Bad Config Some needed configuration parameter has
not been set
Check all required handset configuration
parameters for valid settings
Bad ESSID The handset is configured for “static ESSID”
(as opposed to “Learn once” or “Learn
always” and no ESS ID has been entered.
Enter an ESSID in the configuration
settings or change to one of the “Learn”
modes.
Bad Phintl File Handset software download files are
incorrect or corrupted
Download new software from the
SpectraLink site per Software
Maintenance .
Bad Program File Handset software download files are
incorrect or corrupted
Download new software from the
SpectraLink site per Software
Maintenance .