License management, 1 requirements, 2 configuration process – Polycom SpectraLink NetLink E340 User Manual
Page 30
SpectraLink Corporation
Configuration and Administration—NetLink e340/i640 Wireless Telephone
Cisco CallManager and IP Phone 7960 Emulation
72-1082-02-G.doc
Page 30
5. License Management
NetLink Wireless Telephones support a number of different IP protocol
integrations. All NetLink e340/i640 Wireless Telephones are shipped from
SpectraLink with a generic software load that allows them to associate to a wireless
LAN and download their functional software from a TFTP server. The handsets
will not function properly without downloading appropriate software.
The following details the process to properly configure NetLink e340/i640 handsets
and download software via over-the-air file transfer.
5.1 Requirements
• A wireless LAN must be properly configured and operational through the use of
802.11b wireless APs.
• Cisco’s CallManager (Release 3.08 or greater) must also be connected to your
network and completely operational.
• A TFTP server must be available on the network in order to load the appropriate
software into the handsets. Most installations choose to take advantage of the
TFTP server that accompanies the CallManager, making a separate TFTP server
unnecessary.
• Finally, ensure that the Battery Pack on the handset is fully charged.
5.2 Configuration Process
1. Download the latest NetLink e340/i640 Wireless Telephone IP software from
Scroll to
NetLink e340/i640 – Cisco; Cisco SCCP – 7960 emulation
and click
the hyperlink to start the download.
2. Load the latest version of the SCCP code and place it on the TFTP server and
ensure the TFTP server is started. The five files that are needed must be named:
slnk_cfg.cfg
pd11gl3.bin
pd11skd.bin
pd11skd3.bin
pi110001.bin
3. If statically assigning IP addresses, ensure that the Phone IP address, TFTP
server IP, Subnet Mask, and Default Gateway information are accurate in the
Admin menu. If using a DHCP server, ensure that appropriate options are set
for the TFTP server. See the NetLink Wireless Telephone Configuration section
for detailed configuration instructions.
4. Ensure the handset has properly configured ESSID and Reg Domain
Information within the Admin menu. If you are accepting broadcast ESSIDs at
your APs, the handset will automatically learn the ESSID information when
powering on. See NetLink Wireless Telephone Configuration section for detailed
configuration instructions.