Polycom SpectraLink NetLink E340 - Manual (Page 13)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Cisco CallManager and IP Phone 7960 Emulation
72-1082-02-G.doc Page 13
3.3 Startup Sequence
The handset goes through an initialization sequence at startup. The line icons 1-9
display and count down as the handset steps through this sequence. This is usually
very rapid. If there is any difficulty at any step that prevents initialization from
continuing, an error message will display and the related icon(s) will stay on. Please
see the error table at the back of this document for instructions on how to handle
error messages that occur during initialization.
Icon The icon(s) shown in bold turns off when:
123456789 The handset has located and authenticated and associated with at least one AP, and is proceeding to
bring up higher-layer networking functions.
12345678 The handset is either configured for Static IP, or if configured for DHCP the DHCP discovery process
has started.
1234567 If DHCP is configured, a DHCP response was received which contains a good DNS server configuration.
123456 Note: Only valid on non-SRP protocol. Indicates one of the following:
Static IP configuration, or
SVP Server address found in DHCP response, or
SVP Server address found via DNS lookup.
12345 All networking functions are complete (notably, DHCP) and the handset is proceeding with
establishing the SRP link to the SVP Server.
1234 The SRP link is established, all network stack initialization is complete, proceeding with application-
specific initialization.
123 The link between the handset and the TFTP server is established. The handset displays Trying TFTP
[n] . [n] is the retry count.
12 The handset has opened a connection to the CallManager. The handset displays Opening .
1 The handset has registered to the CallManager. The handset displays Registering [n] . [n] is the
progress down counter while performing the registration. The start number depends on the
CallManager version.
(no icons)
EXT. XXXXX
Initialization is complete. The handset is in standby mode ready to receive and place calls.