Polycom SpectraLink NetLink E340 - Manual (Page 19)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Cisco CallManager and IP Phone 7960 Emulation
72-1082-02-G.doc Page 19
Admin Menu Items 2 nd Level 3 rd Level 4 th Level 5 th Level
Diagnostics Run Site Survey
Diagnostics Mode Diagnostics On
*Diagnostics Off
Syslog Mode *Disabled
Errors
Events
Full
Restore Defaults
* default setting
† 50 mW and 30 mW only appear if Regulatory Domain is set to None or 01.
Phone Config
License Option
License Option lets you select the VoIP protocol that your site is licensed to
download and run. The SCCP protocol to use for the handsets is 008 . Any other
protocol will cause the handset to malfunction.
Push-to-talk
All eight push-to-talk channels are allowed by default. To toggle the allowed status of
any channel, select Allowed Channels , scroll to the channel to be disallowed and
press the Select side button. Allowed channels are displayed with an * in the left
column. Only those channels allowed in the Admin menu will appear on the Standby
menu where they can be enabled or disabled by the end user. To disallow push-to-
talk entirely, select Allow/Disallow , scroll to and select Disallow PTT .
Admin Password
The Admin Password controls access to the administration functions in the Admin
menu. The password must be set in each handset for which controlled access is
desired. Handsets are shipped without any Admin menu password. Data entry for
the password uses the alphanumeric string entry technique. Type the password and
press the Save softkey. A confirmation prompt will appear. Type the password again
and press the Save softkey. If the passwords match, the Admin password has been
set.
If you Save with no entry, the password is erased and the display will not
require it before displaying the Admin menu.
Network Config
IP Addresses
There are two modes in which the handset can operate: DHCP enabled or Static IP.
Select the mode from the IP address menu: