Command line interface, Overview, Access platforms – Perle Systems IOLAN SCS User Manual
Page 52: Unique features, Connecting to the iolan using the cli, Through the network
Command Line Interface
52
IOLAN SDS/SCS/STS User’s Guide, Version 3.6
Command Line Interface
Overview
The Command Line Interface (CLI) is a command line option for IOLAN configuration/management.
See the Command Line Interface Reference Guide for a full breakdown of all the CLI commands and
their functionality.
Access Platforms
The CLI is accessed by any application that supports a Telnet or SSH session to the IOLAN’s IP
address, such as Putty, SecureCRT, or from a command prompt. You can also access the CLI from a
dumb terminal or PC connected to a serial port.
Unique Features
The CLI supports the following unique features:
z
You can access the IOLAN from any application that supports Telnet or SSH.
z
Ability to clear the ARP table (cache).
z
For existing IOLAN+ customers, the native IOLAN+ CLI to be used by entering the
iolan+
command. See your IOLAN User’s Guide for information on using the IOLAN+ CLI.
Connecting to the IOLAN Using the CLI
There are two ways you can access the IOLAN, through the network (Ethernet connection) or
through the serial connection. If you are accessing the IOLAN through the network, the IOLAN must
already have a known IP address configured; see
Using a Direct Serial Connection to Specify an IP
getting started for information on configuring an IP address.
Through the Network
To connect to the IOLAN through the network to configure/manage it using the CLI, do the
following:
1.
Start a Telnet or SSH session to the IOLAN’s IP address; for example:
telnet 10.10.201.100
2.
You will get a
Login:
prompt. You can login as the admin user or as a user with Admin Level
rights. If the login is successful, you will get a prompt that displays the IOLAN model and
number of ports:
Login: admin
Password:
SDS2#
You will see a prompt that displays the model and number of the IOLAN. You are now ready to
start configuring/managing your IOLAN using the CLI.
Note:
The IOLAN+ CLI is not supported on IOLAN models with more than 16 ports or the
DS1/TS2 model.