Perle Systems IOLAN SCS - Manual (Page 338)

RADIUS
338 IOLAN SDS/SCS/STS User’s Guide, Version 3.6
Accounting Message
This section describes the attributes which will be included by the IOLAN when sending an
accounting message to the RADIUS server.
Type Name Description
1 User-Name The name of the user to be authenticated.
4 NAS-IP-Address IP Address of IOLAN LAN interface.
5 NAS-Port Port Line number of IOLAN.
6 Service-Type Indicates the service to use to connect the user to the
IOLAN. A value of 6 indicates administrative access to
the IOLAN. Supported values are:
z 1—Login
z 3—Callback-Login
Equivalent to the IOLAN User Service set by Type
15, Login-Service.
z 2—Framed
z 4—Callback-Framed
Equivalent to the IOLAN User Service set by Type
7, Framed-Protocol.
z 7—NAS prompt
z 9—Callback NAS-prompt
Equivalent to IOLAN User Service DSPrompt .
z 6—Administrative User
z 11—Callback Administrative User
Equivalent to IOLAN User Service DSPrompt and the
User gets Admin privileges.
40 Acct-Status-Type Indicates if this is the beginning or end of a session.
Supported values are: 1 = Start 2 =Stop.
42 Acct-Input-Octets Number of bytes which were received from the user
during this session.
43 Acct-Output-Octets Number of bytes where were transmitted to the user
during this session.
44 Acct-Session-ID A string which identifies the session. The same string
must be used in the start and stop messages.
45 Acct-Authentic Indicates how the user was authenticated. Supported
values are: 1 = Local 2 = RADIUS.
46 Acct-Session-Time Number of seconds for which the user has been
connected to a specific session.
47 Acct-Input-Packets Number of packets which were received from the user
during this session.
48 Acct-Output-Packets Number of packets which were transmitted to the user
during this session.
49 Acct-Terminate-Cause Indicates how the session was terminated: Supported
values include: 1 = User Request 2= Lost Carrier
3=Lost Service 4= Idle Timeout 5= Session Timeout
14 = Port Suspended 16 = Callback.