Perle Systems IOLAN SCS - Manual (Page 125)

125
Serial Port Profiles
Enable Data
Logging When enabled, serial data will be buffered if the TCP connection is lost. When
the TCP connection is re-established, the buffered serial data will be sent to its
destination (this option is not available when
Monitor DSR , Monitor DCD , or
Multihost is enabled).
The data buffer is 4K for desktop models and 32K for rack mount models. If
the data buffer is filled, incoming serial data will overwrite the oldest data.
Default: Disabled
Idle Timeout Use this timer to close a connection because of inactivity. When the Idle
Timeout expires, the IOLAN will end the connection.
Range: 0-4294967 seconds (about 49 days)
Default: 0 seconds so the port will never timeout
Session Timeout Use this timer to forcibly close the session/connection when the Session
Timeout expires.
Default: 0 seconds so the port will never timeout
Range: 0-4294967 seconds (about 49 days)
Dial In If the device is remote and will be dialing in via modem or ISDN TA, enable
this parameter.
Default: Disabled
Dial Out If you want the modem to dial a number when the serial port is started, enable
this parameter.
Default: Disabled
Dial Timeout The number of seconds the IOLAN will wait to establish a connection to a
remote modem.
Range: 1-99
Default: 45 seconds
Dial Retry The number of times the IOLAN will attempt to re-establish a connection with
a remote modem.
Range: 0-99
Default: 2
Modem The name of the predefined modem that is used on this line.
Phone The phone number to use when Dial Out is enabled.