Perle Systems DS1 - Manual (Page 97)

Command Line Interface 97
Line Commands
Set Vmodem
Description Configures the vmodem settings for the serial line.
User Level Admin
Syntax
Options failure-string
success-string
host
port
style
suppress
Show Interface
Description Shows the network interface information.
User Level Admin
Syntax
Show Telnet-Client
Description Shows the telnet client settings for a line.
User Level Admin
Syntax
Show UDP
Description Shows the UDP settings for the line.
User Level Admin
Syntax
<end_ip_address>
The last host IP address in the range of IP addresses (for IPV4, not required for IPV6)
that the Device Server will listen for messages from and/or send messages to.
set vmodem line [failure-string <string>]
[success-string <string>] [host <config_host>]
[port <TCP_port>|0] [style numeric|verbose] [suppress on|off]
String that is sent to the serial device when a connection fails. If no string is entered,
then the string
NO CARRIER will be sent.
String that is sent to the serial device when a connection succeeds. If no string is
entered, then the string CONNECT will be sent with the connecting speed, for example
CONNECT 9600 .
The target host name.
The port number the target host is listening on for messages.
One of the following:
z Verbose—Return codes (strings) are sent to the connected device.
z Numeric—The following characters can be sent to the connected device:
1 Successfully Connected
2 Failed to Connect
4 Error
If set to No , connection success/failure indication strings are sent to the connected
device, otherwise these indications are suppressed.
show interface [brief|ethernet]
show telnet-client
show udp