Line commands, Set line – Perle Systems DS1 User Manual
Page 90
Line Commands
90
IOLAN Device Server User’s Guide, Version 1.0
Line Commands
Line Commands
Set Line
Description Configures line parameters.
User Level Normal, Admin
Syntax
set line [data-bits 5|6|7|8] [dial none|in|out|both]
[idle-timer <0-4294967>] [line-name <name>]
[modem-name <config_modem>] [pages 1|2|3|4|5|6|7]
[parity none|even|odd|mark|space] [phone-number <phone_number>]
[rev-sess-security on|off] [sess-timer <0-4294967>]
[stop-bits 1|2|1.5] [termtype wyse60|vt100|ansi|dumb|tvi925|
ibm3151te|vt320|hp700|term1|term2|term3]
Admin
set line ... [break on|off] [flowin on|off] [flowout on|off]
[hotkey-prefix <00-7f>] [initial cli|menu] [keepalive on|off]
[lock on|off] [motd on|off] [reset on|off] [user <name>]
[nouser]
Options
data-bits
Specifies the number of bits in a byte. The default is
8
.
dial
Determines how a modem will work on the line. If your user is remote and will be
dialing in via modem or ISDN TA, set this parameter to
In
; if the Device Server is
being used as a router, set this parameter to either
In
,
Out
, or
Both
, depending on which
end of the link your Device Server is situated and how you want to initiate the
communication.
idle-timer
Enter a time period, in seconds, for which the idle timer will run. Use this timer to close
a connection because of inactivity. When the idle timer expires, the Device Server will
end the connection. The maximum value is 4294967 seconds (about 49 days). The
default value of
0
(zero) means the idle timer will not expire, so the connection is
permanently open.
line-name
Provide a name for the line so it can be easily identified. The
Remote Port Buffering
logging feature uses the
Line Name
when creating a file on the remote NFS server.
modem-name
The name of the predefined modem that is used on this line.
pages
For
DSLogin
line service, this is the number of video pages the terminal supports. Valid
values are 1-7. The default is
5
pages.
parity
Specifies if you are using
Even
,
Odd
, or
No parity
on the line. If you want to force a
parity type, you can specify
Mark
for 1or
Space
for 0.
phone-number
The phone number to use when
Dial
is set to
Out
.