Perle Systems DS1 User Manual
Page 91
Command Line Interface 91
Line Commands
rev-sess-security
Enables/disables login/password authentication, locally or externally, on reverse Telnet
connections. The default is
Off
.
sess-time
Enter a time, in seconds, for which the session timer will run. Use this timer to forcibly
close the session (connection). When the session timer expires the Device Server will
end the connection. The default value is
0
seconds so the port will never timeout. The
maximum value is 4294967 seconds (about 49 days).
break
Specifies how a break is interpreted:
z
None—The Device Server ignores the break key completely and it is not passed
through to the host. This is the default setting.
z
Local—The Device Server deals with the break locally. If the user is in a session,
the break key has the same effect as a hot key.
z
Remote—When the break key is pressed, the Device Server translates this into a
telnet break signal which it sends to the host machine.
z
Brkintr—On some systems such as SunOS, XENIX, and AIX, a break received
from the peripheral is not passed to the client properly. If the client wishes to make
the break act like an interrupt key (for example, when the stty options
-ignbrk
and
brkintr
are set).
flowin
Determines if input flow control is to be used. Default is
On
. This is active only when
Line Flow Control
is set to
Soft
,
Hard
, or
Both
.
flowout
Determines if output flow control is to be used. Default is
On
. This is active only when
Line Flow Control
is set to
Soft
,
Hard
, or
Both
.
hotkey-prefix
The prefix that a user types to lock a line or redraw the Menu. The default value is
hex
01
, which corresponds to
Ctrl-a
(
^a
) (hex value 02 would be Ctrl-b (^b), etc.):
z
^a l
—(Lowercase L) Locks the line until the user unlocks it. The user is prompted
for a password (any password, excluding spaces) and locks the line. Next, the user
must retype the password to unlock the line.
z
^r
—When you switch from a session back to the Menu, the screen may not be
redrawn correctly. If this happens, use this command to redraw it properly.
You can use the
Hotkey Prefix
key to lock a line only when the
Line
Lock
parameter is
On
.
initial
Specifies the initial interface a user navigates when logging into the line; either the
Menu
or a prompt for the
CLI
. The default is
CLI
.