Server commands, Set server – Perle Systems DS1 User Manual
Page 77
Command Line Interface 77
Server Commands
Server Commands
This section defines all the CLI commands associated with configuring the Device Server’s server
parameters.
Server Commands
Set Server
Description Sets server parameters.
User Level Admin
Syntax
set server [banner on|off] [bypass-password on|off]
[domain
[internet
[password-limit <0-10>] [prompt-with-name on|off]
[single-telnet on|off] [subnet-bit-length <0-32>]
set server tftp [retry
Options
banner
This parameter concerns the banner information (product name/software version). This
banner information is presented to a user with a login prompt. For security reasons, you
can turn off the display of this information. The default is
Off
.
bypass-password
When set, authorised users who do not have a password set, with the exception of the
Admin user, WILL NOT be prompted for a password at login with
Local
Authentication
.
domain_name
Unique name for your domain, your location in the global network. Like Hostname, it is
a symbolic, rather than a numerical, identifier.
flush-on-close
When enabled, deletes any pending data when a port is closed; as opposed to
maintaining the port to send pending data. The default value is
Off
.
internet
The Device Server’s unique IPv4 network IP address. If you are using the Device
Server in an IPv6 network, this field can be left blank.
oem-login
When set, and a custom language file is in use, the login prompt will use the string
defined in the language file as the login prompt instead of the default prompt,
login:
.
password-limit
The number of attempts a user is allowed to enter a password for a port. If this limit is
exceeded, the port is disabled for 5 minutes. A user with Admin level rights can restart
the port, bypassing the timeout, by issuing a kill on the disabled port. The default value
is
3
.