Printronix L1024 - Manual (Page 58)

3–14 Configuring the Printer
Factory Settings
Table 3–1 lists the the factory default settings (i.e., Config. 0). These values are
available for loading at any time, and are maintained in the printer until a new
configuration is loaded.
Table 3–1. Factory Settings
Paper Control
Image Width
Paper Length
Hor Image Shift
Vert Image Shift
Reprint on Fault 8.2 inches
11.0 inches
3/20 inches
0/100 inches
Enabled
Mode
Impact Printer
PCL5 (optional)
IGP/PGL (optional)
IGP/VGL (optional)
CTHI (optional)
IPDS (optional)
Impact Printer
(Refer to the Impact Printer
User’s Manual for defaults.)
Maint / Misc
Panel Key Sound
Alarm
Power–up State
Hex Dump Mode
PTX_SETUP Option
SETUP PARSE
SETUP SFCC
Display Language
On
On
Online
Disable
Enable
21h
English
Host Interface
Centronics
Data Bit 8
Paper Inst Line
Data Polarity
Strobe Polarity
Output Polarity
Paper Instruction Polarity
Strobe Filter
Fast Busy
Trailing Edge
Twinax or Centronics
Enable
Disable
Standard
Standard
Standard
Standard
Enable
Enable
Enable