Printronix L1024 - Manual (Page 39)

2–21 Setting Up the Printer
Cable Connections
Now the printer can be connected to power and to your system. To connect the
cables, refer to Figure 2–13 and perform the steps listed below.
WARNING
To prevent injury to yourself or damage to the printer, make sure the
printer is connected to a proper power source.
WARNUNG
Um Personenschäden oder eine Beschädigung des Druckers zu
verhindern, sicherstellen, daß der Drucker an eine geeignete
Stromquelle angeschlossen ist.
ATTENTION
S’assurer que l’imprimante est branchée afin d’éviter tout risque de
blessures corporelles ou de dommages à l’imprimante.
1. Verify that the site line voltage is the same as the voltage specified in
“Check the Power Requirements” section, page 2–3.
2. Make sure the printer power switch is set to 0 (OFF).
3. Connect the power cord (supplied with the printer) to the AC power
connector on the printer.
NOTE: To avoid possible electrical interference, separate the AC power
cord and the interface cable.
4. Connect the opposite end of the power cord to the AC line receptacle.
5. Connect the interface cable to the appropriate printer interface connector
and to the host computer. The printer supports a variety of standard and
optional interfaces:
•
Centronics parallel
•
Dataproducts parallel (requires optional cable adapter)
•
RS–232 and RS–422 serial
•
Coax/Twinax (option)
•
Local Area Network (option)