Printronix L1024 - Manual (Page 121)

C–1 Media Requirements
C
Media Requirements
The printer requires continuous form electrographic grade media with 0.5 inch
pitch tractor feed pin holes. The media capabilities and requirements are listed
below:
Width 4.0 to 10.0 inches edge to edge
(3.5 to 9.5 inches pin to pin)
Length 3.0 to 33.0 inches
in 1/8 or 1/6 inch increments
Weight 18 to 42 lb. bond (67 to 158 g/m 2 )
110 lb. tag stock
99 lb. card stock
Labels:
Face Stock 40 to 60 lb. book stock (60 to 90 g/m 2 )
Carrier 50 lb. book stock (75 g/m 2 )
Adhesive acrylic
Cut to Tie (page perf)
≥
2.9:1 (8 cuts/inch) bond (and microperf)
≥
6.5:1 (4 cuts/inch) tag/card stock
≥
6.5:1 (4 cuts/inch) label stock
Percent Recycled paper 20% maximum
Moisture Content 5% + 1%
Resistivity 10 8 to 10 12 ohms
NOTE: Bond paper weight based on 17 X 22 inch base size. Tag stock
based on 24 X 36 in base size. Card stock based on 22 1/2 X 28 1/2
inch base size. Book carrier stock based on 25 X 38 inch base size.