Polaris Offroad Vehicle - Manual (Page 60)

50
CONTROL AND PARTS FUNCTIONS
4 Cycle Premium 4 Synthetic Lubricant
Polaris Premium 4 All Season Synthetic engine oil has been specially formulated
for use in Polaris 4 cycle engines. It is a fully synthetic, high performance, multi-vis-
cosity oil designed to provide the ultimate in lubrication performance and protec-
tion.
Premium 4 possesses unsurpassed film strength over the widest possible temper-
ature range. It resists viscosity and frictional breakdown in ambient temperatures
from -40° F to 120° F. Its exceptional frictional properties result in more efficient
operation, more power output and lower fuel consumption.
Although Polaris Premium 4 is the only oil recommended for use in this engine, use
of any API certified “SH” oil is allowable. Oil may need to be changed more fre-
quently if Polaris Premium 4 is not used. You will also need to follow the manufac-
turers recommendations for ambient temperature operation.
Oil System
The oil tank is located on the left side of the vehicle. To check the oil:
1. Set machine on a level surface.
2. Start the engine and let it
idle for 20-30 seconds.
3. Stop the engine, remove
dipstick and wipe dry with a
clean cloth.
4. Screw in the dipstick
completely, remove it and
read the oil level. NOTE:
The dipstick must be
screwed in to keep the
angle and depth of stick
consistent.
5. Remove dipstick and check to see that the oil level is between the full and add
marks. Add oil as indicated by the level on the dipstick. Do not overfill.
CAUTION: Use only Polaris Premium 4 All Season synthetic oil (PN 2871271), or
API certified “SH” oil. Never substitute or mix oil brands. Serious engine damage
and voiding of warranty can result.
Oil and Filter Change
The recommended oil change interval is 100 hours, 1000 miles, or every six
months, whichever comes first. Suggested break in oil change is at 20 hours, 500
miles, or one month, whichever comes first. Severe use operation requires more
frequent service. Severe use includes continuous duty in dusty or wet conditions,
and cold weather riding. NOTE: Severe use cold weather riding is all riding below
10° F, and riding between 10° F and 30°F when most trips are slow speed and less
than 5 miles. Be sure to change the oil filter whenever changing oil (Polaris PN
3084963)
1. Place vehicle on a level surface.
2. Clean area around drain plug at the bottom of the oil tank.
3. Run engine for two to three minutes until warm. Shut engine off.
ADD 8 OZ. NORMAL FULL
Maintain Oil Level In Normal Range