Printronix P3000 Series - Manual (Page 42)

Configuration 3–6
Load Configuration Values
The previously saved default value set or the permanently stored Printronix factory value set can be
loaded for use as needed. This procedure provides a convenient method of resetting the printer con-
figuration to a known value set.
1. Place the printer off line by pressing ON LINE. Enable the ENTER switch by pressing MENU
UP and MENU DOWN simultaneously. ENTER SWITCH NOT LOCKED temporarily appears
in the message area.
2. Select and display the LOAD PARAMETERS main menu by pressing MENU DOWN and then
NEXT or PREV VALUE.
3. Press MENU DOWN and then NEXT or PREV VALUE to select either the LOAD SAVED PA-
RAMETERS or LOAD FACTORY PARAMETERS menu. If an IGP, IBM 3287, or IBM 5225
emulation board is installed, select the appropriate standard configuration listed in this menu.
4. Press ENTER once the desired selection is shown in the message display. The display then reads
LOAD SAVED COMPLETED or LOAD FACTORY COMPLETED.
5. After all parameters have been changed as required, select the SAVE PARAMETERS main
menu and press ENTER. This saves the current parameter values as the default values.
6. Press CLEAR to return to OFFLINE READY.
7. Disable the ENTER switch by pressing MENU UP and MENU DOWN simultaneously. Place
the printer on line by pressing ON LINE.