Printronix P3000 Series - Manual (Page 142)

Programming 6–56
Printer Reset
ASCII Hex Decimal
P–Series SFCC @ SFCC 40 SFCC 64
Serial ESC @ 1B 40 27 64
Purpose Initializes all print mode related parameters to values previously saved.
Comment When reset to the previously saved values, the current line is set to the top–of–form
position. Print mode, line spacing, international language selection, form length,
skip–over perforation, and character pitch are reset to previously saved values. (In
the Serial Matrix protocol, this command sets horizontal tabs at every eighth char-
acter column.) Character–by–character and line–by–line attributes are canceled.
The vertical format unit is cleared. Interface parameters and emulation mode (P–Se-
ries or Serial Matrix) are not affected.