Printronix P3000 Series - Manual (Page 134)

Programming 6–48
Line Spacing 1/8 Inch (8 lpi)
ASCII Hex Decimal
P–Series SFCC LPI;n
SFCC 0
SFCC 30 SFCC 48
Serial ESC 0 1B 30 27 48
Purpose Specifies continuous line spacing at 1/8–inch increments (8 lpi).
Comment When the 1/8–inch line spacing control code is received, all lines are printed at 8 lpi
until a new line spacing is selected or the power is reset. The control code line spac-
ing selection overrides the control panel line spacing setting and 8 lpi is reflected on
the display when the 6/8 LPI switch is pressed.
The value of n can only be 6 or 8. When using SFCC LPI;n in the P–Series mode and
n = 8, this command sets line spacing to 1/8 inch. Values of n other than 6 or 8 cause
an error message (Command Line Error Messages are listed on page 6–3).
Example The following example illustrates 1/8–inch line spacing.