Lanier AP206 - Manual (Page 76)

Cleaning and Adjusting the Printer
63
4
Adjusting the Image Density
Changing the image density setting
might cause a deterioration of color
balance. We recommend that you
normally leave the image density at
its factory default setting.
The following procedure describes
how to change the magenta image
density. You can use the same proce-
dure to change the image density for
the other toner colors as well.
Important
❒ Extreme settings may create out-
put that appears dirty.
❒ Image density settings should be
made from the application or the
printer driver whenever possible.
A
Turn on the printer's power
switch.
B
Press
{{{{Menu}}}}.
The following message appears on
the panel display.
IPDL-C Menu l
C
Press
{{{{T T T T}}}} or {{{{U U U U}}}} to display
"Maintenance", and then press
{{{{#Enter}}}}.
Maintenance l
The following message appears on
the panel display.
j
1.Toner Level l
D
After confirming that “1. Toner
Level” is on the display, press
{{{{#Enter.}}}}
The following message appears on
the panel display.
j
Cyan l
E
Press
{{{{T T T T}}}} or {{{{U U U U}}}} to display "Ma-
genta", and then press
{{{{#Enter}}}}.
The following message appears on
the panel display.
jl/#
-<-----g----->+
F
Press
{{{{U U U U}}}} or {{{{T T T T}}}} to adjust the
toner density, and then press
{{{{#Enter}}}}.
The "Toner Level" menu appears.
Note
❒ To make the image density
darker, press
{U U U U} to move the g
symbol to the right. To make it
lighter, press
{T T T T} to move the g
symbol to the left.
G
Press
{{{{On Line}}}}.
The "Ready" message appears on
the panel display.
Power On Line Data In
Reset
Escape Menu
Media Enter
Error
ZDHS031E