Lexmark 7600 Series - Manual (Page 139)

3 Press the up or down arrow button until Country is highlighted, and then press OK.
4 If the country or region name is correct, press OK to save the setting.
5 If you want to change the country or region, press the up or down arrow button until the country or region
where you are operating the printer is highlighted, and then press OK to save the setting.
I
S YOUR PRINTER MEMORY FULL
?
1 Dial the receiving number.
2 Scan the original document one page at a time.
Can send but not receive faxes
These are possible causes and solutions. Try one or more of the following:
L
OAD PAPER
Load paper to print any faxes that have been stored in the printer.
M
AKE SURE THE
A
UTO
A
NSWER IS ON
If the Auto Answer light is on:
• The printer will answer after the preset number of telephone rings.
• If you are using a distinctive ring, see the instructions for setting a distinctive ring.
1 From the printer control panel, press .
2 Press the up or down arrow button until Fax Setup is highlighted, and then press OK.
3 Press the up or down arrow button until Ringing and Answering is highlighted, and then press OK.
4 Press the up or down arrow button until Auto Answer is highlighted, and then press OK.
5 Press the up or down arrow button until On is highlighted, and then press OK to save the setting.
C
HECK INK
Check the ink levels, and install a new cartridge if necessary.
C
HECK WHETHER
F
AX
F
ORWARDING IS SELECTED
1 From the printer control panel, press .
2 Press the up or down arrow button until Fax Setup is highlighted, and then press OK.
3 Press the up or down arrow button until Ringing and Answering is highlighted , and then press OK.
4 Press the up or down arrow button until Fax Forward is highlighted, and then press OK.
5 To turn off Fax Forwarding, press the up or down arrow button until Off is highlighted, and then press OK.
Troubleshooting
139