Kodak ESP 9200 - Manual (Page 60)

Faxing
54 www.kodak.com/go/aiosupport
• Digital subscriber line (DSL) — telephone service that uses the wires of a local
telephone network to transmit digital data over cables
Connect one end of the phone cord into the LINE IN port on the back of the
printer and the other end into the DSL filter (available from your DSL provider),
which is connected to the wall phone jack.
NOTE: You must use a DSL filter to transmit fax signals properly to your printer.
3. Determine whether your phone line is shared or dedicated.
• A dedicated phone line is one that has only this printer and no other devices
connected to it. If you have a dedicated line, connect your printer as shown for
step 2 above.
• A shared phone line is one that has several devices connected to it, such as a
phone and/or answering machine as well as the printer. If you have a shared
line, connect your printer in one of the following ways, based on the devices
you have connected to the same phone line.
If you share the line with an answering machine or telephone :
a. Connect one end of the phone cord that came with the printer into the LINE
IN port on the back of the printer.
b. Connect the other end of the phone cord into either a wall phone jack or a
DSL filter, depending on the type of telephone service you use (see step 2
above).
c. Connect one end of the phone cord for your answering machine into the
LINE EX port on the back of the printer.
d. Connect the other end of the phone cord into the answering machine or
telephone.
DSL filter