Kodak ESP 9200 - Manual (Page 10)

Printer Overview
4 www.kodak.com/go/aiosupport
Configuring printer settings
NOTE: When you first power on the printer, the LCD prompts you to select the
Language and Country/Region .
To set or change basic printer settings:
1. Press Home .
2. Press to select Printer Settings , then press OK .
3. Press to select one of the following settings:
• Date and Time
– Press OK , then press to select Year , Month , Day , Hour , or Minute .
Press or to change the values; press OK when you are done.
NOTE: You can also synchronize the printer date and time to your computer using
the Home Center Software.
• Button Sounds
– Press to select Loud , Off , or Soft .
• Time to Low Power
To conserve energy, your printer will enter a low power (sleep) mode after
being idle for a default delay time of 1 hour. You can increase the delay time to
low power (in 0.5 hour increments) up to 4 hours. Increasing the delay time
may result in reduced energy savings.
– Press to change the time to energy-saving sleep mode (select from 1 to
4 hours in 0.5 hour increments).
• Tagged Image Printing (see Printing tagged pictures, page 37 )
– Press to select Off or On .
• Language
– Press OK , press to select a language, then press OK .
• Country/Region
– Press OK , press to select a country or region, then press OK .
• Reset All Settings (see Resetting factory defaults, page 76 )
NOTE: Resetting factory defaults does not change the date and time, language,
country/region, or network settings.
4. Press Back to return to the Main Menu.