Kodak ESP 9200 - Manual (Page 18)

Networking Your Printer
12 www.kodak.com/go/aiosupport
Adding a network connection to a USB-connected computer
You can change the way you connect to your printer at any time.
Changing from USB to a wireless connection
To change the printer connection type from USB to a wireless (Wi-Fi) network:
If your printer is connected to a computer with WINDOWS OS:
1. Unplug the USB cable from your printer and computer.
2. On the printer control panel, press Home .
3. Press to select Network Settings , then press OK .
4. Press to select View Network Configuration , press OK , then confirm you have
a non-zero IP address.
5. If you have not already done so, connect your printer to your wireless network.
See Connecting to a wireless network, page 5 .
6. On your computer, disable any firewall you have installed until you have
successfully completed the installation. For more information on firewalls, go to
www.kodak.com/go/inkjetnetworking.
7. Select Start > All Programs > Kodak > Kodak Printer Network Setup Utility .
• If your wireless all-in-one printer (example: KodakESP9200+0069) is not
listed:
a. Select No, my printer is not listed , then click Next .
b. Select your printer from the list.
c. Select Network - Wireless/WiFi , then click Next .
When your printer is detected, driver installation begins.
• If your wireless all-in-one printer (example: KodakESP9200+0069) is listed:
a. Highlight the all-in-one printer that is connected to your network.
b. Select Yes, my printer is listed , then click Next .
When your printer is detected, driver installation begins.
8. When driver installation is complete, click Done .
The printer with a wireless connection is listed as the name of the printer plus a
number (for example, KodakESP9200+0069).