Kyocera FS-820 - Manual (Page 45)

Finishing
User Guide 5-4
The top two settings (e.g. A4/Letter) are for the smaller size paper in the mixed
page document.
The second row of settings (e.g. A3/Legal/Ledger) is for the larger size paper in
the mixed page document.
Select the one setting that best illustrates the edge of the mixed pages you want to
align. Note that a change to one custom Finishing edge setting adjusts other
selections to make them compatible with the change.
Gutter
Based on the page size and print size specified in the Basic tab, you can reduce or
enlarge the image from 20% to 500% of the original size, or increase the top or left
margin, before printing.
Click Gutter to increase the outside margins in a range from 5.0 to 25.4 mm (0.20 to
1.00 inch). The left and/or top margins can be adjusted. This is useful when you want
to add extra margin space to the page for staples or hole punches. When used with
duplex printing, the enlarged gutter lines up evenly on both sides of the sheet. For
further details on duplex printing, refer to
Duplex Printing on page 3-6.
• To increase outside margins on the left side of the page, enter a number into the
Left (long edge) box. This option may not be available, depending on your
Orientation and Print on both sides settings in the Basic tab.
• To increase outside margins at the top of the page, enter a number into the Top
(long edge) box. This option may not be available, depending on your
Orientation and Print on both sides settings in the Basic tab.
• Since the Gutter feature shifts document data to the right or down, select the
Reduce image to fit check box if the printed data extends beyond the edge of
the paper when changing the gutter setting. The size of the printed data is
decreased slightly to fit in the printable margins of the page.
• If the document data is small enough that it does not extend beyond the edge of
the paper when the gutter is increased, clear the Reduce image to fit check
box.
When you want to change the page size (for example, to enlarge an A4-size
brochure for printing on A3 paper), refer to
Print Sizes on page 3-2.
Staple
The Staple feature is available on printing systems with an optional finishing device
installed. If a 3000-sheet finisher and folding unit are installed, the Booklet printing
feature is available. For further details, refer to
Booklet on page 4-1.
After installation, optional equipment must be selected in the printer driver in the
Device Settings tab. For further details, refer to
Installing Optional Devices on
page 2-1.