Kodak 6B8773 - Manual (Page 209)

April 28, 2004 C-1
Appendix C: Troubleshooting
Problems, Causes, and Remedies
Problem Cause Remedy
Camera does not power on Use a fully charged battery or the power
module.
Remove the memory card from the camera and
try to turn the camera on.
Camera does not power on when
the power module is used The power module may not be
fully inserted. Be sure the cable is fully inserted into the power
module (see
page 3-2 ).
• You will feel and hear a soft "click" as the
cable is inserted properly in place.
• You may have to use a considerable amount
of push to "click" the cable in place.
Nothing appears in the Top Status
LCD Battery is exhausted. Replace the battery (see page 3-4 ).
Battery is improperly installed. Insert the battery properly.
Part of the Battery icon is off in
the Top Status LCD Battery is low. Have a fresh battery ready.
The Battery icon blinks in the Top
Status LCD Battery is exhausted. Replace the battery (see page 3-4 ).
Battery is not functioning for
unknown reason Remove, then insert the battery and turn the
camera on.