Kodak 6B8773 - Manual (Page 192)

14-4 April 28, 2004
Camera Care
Inspecting and Cleaning the
Imager
CAUTION :
The imager is very delicate. It is important that you follow
these instructions when inspecting and cleaning the imager.
Failure to do so can damage your camera.
1. Turn off the camera.
2. Remove the lens from the camera.
3. Power on your camera using a fully charged battery.
CAUTION :
If the battery loses charge or the camera power is turned off
during the cleaning procedure, the shutter can close and
damage your camera.
4. Put the camera in Manual Exposure mode (M). See page 7-13 .
5. Choose Imager Clean from the Tools menu, then choose Open.
6. Press the OK button.
The mirror raises and the shutter opens.
7. Inspect the imager according to the TIB procedure at
www.kodak.com/go/dcs .
8. Choose Imager Clean from the Tools menu then choose Close.
9. Press the OK button.
The shutter closes and the mirror returns.
10. Turn off the camera.
11. Replace the lens.