KORG XTENDED DEFINITION D32XD - Manual (Page 122)

112
3e. SEND (EFF/AUX [*/REC])
3e-1. Effect 1 Send
You can adjust the send levels from each mixer channel to
master effect 1.
If you select the pre-fader setting (PRE), the signal will be
sent to the master effect from immediately before the fader,
regardless of the fader level.
With the pre-fader setting, the signal is sent to the master ef-
fect at the same level as when the post-fader (PST) setting is
used with the fader level set to unity (0 dB).
1. PRE/PST
This specifies whether the signal will be sent at the level
immediately before the fader (Pre Fader) or the level
immediately after the fader (Post Fader).
PRE: Send the pre-fader level
PST: Send the post-fader level
2. SEND
Adjusts the send level.
3. Select All
This links the operation of all channels.
It will link the PRE/PST buttons and the SEND knobs.
4. SEND LEVEL meter
Indicates the level of the Effect 1 Send bus.
5. Effect 1 L/R meter
Indicates the level of the Effect 1 Return L/R bus.
6. buttons
Use these up/down buttons to edit the parameter values.
3e-2. Effect 2 Send
Here you can adjust the send levels from each mixer channel
to master effect 2.
For details on the parameters, refer to the section above, “3e-
1. Effect 1 Send.”
3e-3. Aux1 Send
You can adjust the send levels from each mixer channel to the
AUX OUT 1 jack.
If you select the pre-fader setting (PRE), the signal from im-
mediately before the fader will be sent to the AUX OUT jack
regardless of the fader level.
With the pre-fader setting, the signal is sent to the AUX OUT
jack at the same level as when the post-fader (PST) setting is
used with the fader level set to unity (0 dB).
For details on connecting and using external effects, refer to
p.60.
1. PRE/PST
This specifies whether the signal will be sent at the level
immediately before the fader (Pre Fader) or the level
immediately after the fader (Post Fader).
PRE: Send the pre-fader level
PST: Send the post-fader level
2. SEND
Adjusts the send level.
3. Select All
This links the operation of all channels.
It will link the PRE/PST buttons and the SEND knobs.
4. SEND LEVEL meter
Indicates the level of the AUX1 Out.
5. AUX1 Send meter
Adjusts the level of the AUX1 Out.
6. buttons
Use these up/down buttons to edit the parameter values.
3e-4. Aux2 Send
Here you can adjust the send level that is output from each
mixer channel to the AUX 2 jack.
For details on the parameters, refer to the section above, “3e-
3. Aux1 Send.”
1
3
4
5
2
6
D16XD
1
3
4 5
2
6
D32XD
1
3
4
5
2
6
D16XD
6
1
3
4 5
2
D32XD