Siemens Gigaset 3000 - Manual (Page 21)

21
Logging handsets onto a telephone system
You must open a "logon window" in the telephone system
and then log on the handset before you can use it to make
telephone calls.
This is only required when the handset is put into service
for the first time.
A second telephone is needed to open the logon window.
You can enter the name and call number of your system
administrator as well as the handset number and code here:
● Ask your system administrator to provide you with the fol-
lowing information:
– code no. (PIN E1) of the handset
– whether this code no. applies network-wide (in the fol-
lowing, this depends on whether or not you have to ter-
minate the entries listed below with "#")
– code (activates the menu for entering the code no. for
registering and logging on the handset)
– handset number
– handset system PIN (8 digits)
– whether the second telephone is connected at the
same network node
Opening the logon window
Note:
The second telephone can be a logged-on handset or a
Hicom telephone with display, e.g. "Optiset E". It must be
logged on to the same system and connected at the
same network node.
Your system administrator
Tel. no. of system
administrator
Handset number
Code