Cluster ip-pool, Cluster ip-pool -281 – SMC Networks SMC Tiger 10/100 SMC6128L2 User Manual
Page 581
S
WITCH
C
LUSTER
C
OMMANDS
4-281
cluster ip-pool
This command sets the cluster IP address pool. Use the no form to reset
to the default address.
Syntax
cluster ip-pool
- ip-address - The base IP address for IP addresses assigned to cluster
Members. The IP address must start 10.x.x.x.
Default Setting
10.254.254.1
Command Mode
Global Configuration
Command Usage
• An “internal” IP address pool is used to assign IP addresses to
Member switches in the cluster. Internal cluster IP addresses are in the
form 10.x.x.member-ID. Only the base IP address of the pool needs
to be set since Member IDs can only be between 1 and 36.
• Set a Cluster IP Pool that does not conflict with addresses in the
network IP subnet. Cluster IP addresses are assigned to switches when
they become Members and are used for communication between
Member switches and the Commander.
• You cannot change the cluster IP pool when the switch is currently in
Commander mode. Commander mode must first be disabled.
Example
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#