Interface vlan, Interface vlan -199, Vlan c – SMC Networks SMC Tiger 10/100 SMC6128L2 User Manual
Page 499

VLAN C
OMMANDS
4-199
interface vlan
This command enters interface configuration mode for VLANs, which is
used to configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading
zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Related Commands
switchport native vlan Configures the PVID (native VLAN) of
an interface
IC
switchport allowed
vlan
Configures the VLANs associated with
an interface
IC
switchport gvrp
Enables GVRP for an interface
IC
switchport forbidden
vlan
Configures forbidden VLANs for an
interface
IC
switchport priority
default
Sets a port priority for incoming
untagged frames
IC
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
Table 4-56 Configuring VLAN Interfaces
Command
Function
Mode Page