SMC Networks SMC Tiger 10/100 SMC6128L2 User Manual
Page 552
C
OMMAND
L
INE
I
NTERFACE
4-252
Default Setting
• MVR is disabled.
• No MVR group address is defined.
• The default number of contiguous addresses is 0.
• MVR VLAN ID is 1.
Command Mode
Global Configuration
Command Usage
• Use the mvr group command to statically configure all multicast
group addresses that will join the MVR VLAN. Any multicast data
associated an MVR group is sent from all source ports, and to all
receiver ports that have registered to receive data from that multicast
group.
• The IP address range from 224.0.0.0 to 239.255.255.255 is used for
multicast streams. MVR group addresses cannot fall within the
reserved IP multicast address range of 224.0.0.x.
• IGMP snooping must be enabled to a allow a subscriber to
dynamically join or leave an MVR group (see ip igmp snooping on
page 4-230). Note that only IGMP version 2 or 3 hosts can issue
multicast join or leave messages.
Example
The following example enables MVR globally, and configures a range of
MVR group addresses:
Console(config)#mvr
Console(config)#mvr group 228.1.23.1 10
Console(config)#