Show ip dhcp snooping binding, Switch cluster commands, Show ip dhcp snooping binding -278 – SMC Networks SMC Tiger 10/100 SMC6128L2 User Manual
Page 578: Switch cluster commands -278

C
OMMAND
L
INE
I
NTERFACE
4-278
Example
show ip dhcp snooping binding
This command shows the DHCP snooping binding table entries.
Command Mode
Privileged Exec
Example
Switch Cluster Commands
Switch Clustering is a method of grouping switches together to enable
centralized management through a single unit. A switch cluster has a
“Commander” unit that is used to manage all other “Member” switches in
the cluster. The management station uses Telnet to communicate directly
with the Commander throught its IP address, and the Commander
manages Member switches using cluster “internal” IP addresses. There can
be up to 36 Member switches in one cluster. Cluster switches are limited to
within a single IP subnet.
Console#show ip dhcp snooping
Global DHCP Snooping status: disable
DHCP Snooping is configured on the following VLANs:
1
Verify Source Mac-Address: enable
Interface Trusted
---------- ----------
Eth 1/1 No
Eth 1/2 No
Eth 1/3 No
Eth 1/4 No
Eth 1/5 Yes
.
Console#show ip dhcp snooping binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
----------------- ------------ ---------- ------ ---- ---------
11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5
Console#