Siemens 300 H - Manual (Page 87)

Making calls in an "executive/secretary" team
87 87 87 87
Step by Step
and
or Confirm.
Using the call signal function
If a call signal key has been configured on your execu-
tive telephone you can generate a call signal on a partic-
ular destination telephone (for example, in the secre-
tary's office) by pressing this key. When a call signal is
received the number of the calling telephone is dis-
played briefly on the destination telephone.
The key can be pressed (once or several times) when
the phone is idle or while a call is in progress.
If the Call Signal function has not been configured, you
can generate a call signal at a destination telephone by
lifting the handset and entering the call-signal code
number.
Calling a messenger
You can call a messenger at the push of a "Messenger"
key if the appropriate function has been configured on
the executive telephone. The procedure is the same as
described in the section "Storing a repertory dialling
number on a key" (
Æ page 45) - in this case for a mes-
senger.
Designating a deputy for the secretary
The calls for the executive which are normally received
in the secretary’s office can be diverted to a different
telephone. A "Function transfer" key must be configured
for this purpose. The procedure is the same as de-
scribed in the section "Storing a repertory dialling num-
ber on a key" (
Æ page 45) - in this case for a deputy.
To activate deputy:
Press the key. The lamp lights up.
To deactivate deputy:
Press the key. The lamp goes out.
le telephone
Activate?
Deactivate?
Deputy
Deputy