Savin 5450 - Manual (Page 59)

Directional Magnification—Stretching And Squeezing The Image In 1 % Steps
39
1
C
Press the [OK] key.
D
Select [Direct. Mag. (size)] with the
[
→ → → →
] or
{{{{} } } }}}}} key.
E
Press the [OK] key.
F
Enter the vertical original size
with the Number keys and press
the
{{{{
Enter
}}}} key.
Note
❒ To change the value entered,
press the {
Clear/Stop
} key and
enter the new value.
❒ Up to 999 mm, 99.9" can be en-
tered.
G
Enter the vertical print size with
the Number keys and press the
{{{{
Enter
}}}} key.
H
Enter the horizontal original size
with the Number keys and press
the
{{{{
Enter
}}}} key.
I
Enter the horizontal print size
with the Number keys.
J
Press the [OK] key.
The machine will select proper re-
production ratios for vertical and
horizontal directions.
K
Make sure that the original and
the print paper are the correct
size.
L
Set your original on the exposure
glass (contact glass) or in the op-
tional document feeder.
M
Press the
{{{{
Start
}}}} key.
N
Check the image position of the
trial or proof print.
Note
❒ If the image position is not cor-
rect, adjust it using the [Image
=
] key (see
⇒
P.25 “Adjusting
Print Image Position”).
O
Make your prints.
TPES570E
Program Clear Modes
Auto Cycle
Proof
Print
Enter
Start
Clear/Stop
TPES120N
Program Clear Modes
Auto Cycle
Proof
Print
Enter
Start
Clear/Stop
TPES050N