Sharp SND-5080 - Manual (Page 49)

English _49
M
NETWORK
CONNECTION AND
SETUP
If the IP router has more than one camera connected
Configure the IP related settings and the Port related settings distinctly with each other.
Category Camera #1 Camera #2
IP related settings
IP Address
Subnet Mask
Gateway 192.168.1.200
255.255.255.0
192.168.1.1 192.168.1.201
255.255.255.0
192.168.1.1
Port related settings
HTTP Port
VNP Port 80
4520 10000
4530
If the is set other than 80, you must provide the number in the address
bar of the Internet browser before you can access the camera.
ex) http://IP address : HTTP Port
http://192.168.1.201:10000
Auto Network Setup
Run to display the camera search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
support this function.
Select a camera in the search list.
Find the MAC (Ethernet) address labeled
on the rear of the camera.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
Click [Auto Set].
The Auto Setting dialog appears.
The , ,
and will be set automatically.
Enter the password.
This is the login password for the
"admin" user who accesses the
camera. The default password is
"4321".
Click [OK].
Auto network setup will be completed.
The camera will automatically complete
the network setting and restart.
M 
M 
1.
2.
3.
4.
5.