Sharp SND-5080 - Manual (Page 38)

installation & connection
38_ installation & connection
Connecting to the monitor
Connect the [VIDEO] port of the camera to the video input port of the monitor.
In the initial installation of the camera, you can connect the camera to the monitor for checking
the connection status.
You must set to before the display screen can be activated. (page 72)
Connect the monitor test cable to the output port of the monitor.
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
The instructions above are also applied to SND-5080/SND-5080F/SNV-5080.
M 

J 
M 