Overview – Sharp SND-5080 User Manual
Page 14
overview
14_ overview
Reset Button
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
J
Resetting the camera requires reconfiguration of network settings (IP
address, subnet mask, gateway address etc.) using the IP Installer
software application.
Power Port
Used to plug the power cable.
GND
Used for earth-grounding.
Network Port
Used to connect a PoE or LAN cable.
I/O Port
ALARM IN
Used to connect the alarm input signal.
ALARM OUT
Used to connect the alarm output signal.
ALARM COM Common port where the alarm output signal is connected.
GND
Used for earth-grounding.
Video Out Port
Video signal output port connected to the monitor.