Sharp SND-5080 - Manual (Page 48)

48_ network connection and setup
network connection and setup
In the
If using an IP router
IP Address : Enter an address falling in
the IP range provided by the IP router.
ex) 192.168.1.2~254,
192.168.0.2~254,
192.168.XXX.2~254
Subnet Mask : The of
the IP router will be the
of the camera.
Gateway : The of
the IP router will be the of the camera.
The settings may differ depending on the connected IP router model.
For more information, refer to the user manual of the applicable router.
If not using an IP router :
For setting , , and , contact your network
administrator.
In the pane, provide
necessary information.
HTTP Port : Used to access the
camera using the Internet browser,
defaulted to 80. Use the spin button
to change the HTTP Port value.
VNP Port : Used to control the video
signal transfer, defaulted to 4520.
Enter the password.
This is the login password for the "admin" user who accesses the camera.
The default password is "4321".
Click [OK].
Manual network setup will be completed.
When the manual setup including is completed, the camera will restart.
3.
y
y
y
M 
4.
y
y
5.
6.
7.