Sharp R520_CJ16_MM_111009_F4 - Manual (Page 20)

17
Your Phone’s Modes
Standby Mode
Standby mode is the state of the phone once it has found service
and is idle. The phone goes into Standby mode:
• After you power the phone on.
• When you press after a call or from within a menu.
In Standby mode, the time, day, and date as well as all phone
status icons display.
Place Calls in Standby Mode
1. While in Standby mode, enter a phone number, and press
to place a call.
2. Press to return to Standby mode.
Receive Messages in Standby Mode
You can receive messages in Standby mode. An alert tone
sounds and a notification message appears in the display when a
new message arrives.
The following call message options display:
• View Now — This selection allows you to view the messages now.
• View Later — This selection allows you to view the messages at a
later date.
Highlight the desired viewing option and then press .
Adjust the Ringer
In Standby mode, press the Volume key (on the left side of the
phone) up or down.
1. In Standby mode, press the Volume key up or down to set
the call ringer volume as desired. Options are:
2. To enable vibration, press the Vib. on soft key.
3. When you are satisfied with the setting, press SET. The
phone returns to Standby mode.
Tip: You can also enter the Master Volume sub-menu by pressing Menu ➔
Sounds
➔ Master Volume. Use the Volume key on the left side of your
phone to adjust the ringer volume setting.
Note: The Vibrate icon ( ) appears in the display when the phone is in
Vibrate mode. The Vibrate/Ring icon ( ) appears in the display when
the phone is in Ring with Vibrate mode.
• Silence All • Medium
• Vibrate • Medium/High
• Low • High
• Low/Medium