Hardware installation, Chapter 2, “hardware installation – Sun Microsystems 1.0 User Manual
Page 29
3
Hardware Installation
2
This chapter tells you where to find step-by-step procedures for installing PCI
cards. It describes the convention used to assign device names to SunFDDI/P
adapter cards, and tells you how to connect fiber optic cables.
Caution – For your personal safety and to protect your machine, please
observe the following precautions when you install an PCI card in a SPARC™
workstation or server:
Before opening your machine, always ensure that the power switch is off
(O position). When the power is off, the green light on the front of the machine
is unlit and the fan in the power supply is not running. Always take care to
protect your equipment from the effects of static electricity.
A lithium battery is molded into the
NVRAM—TOD
chip on the main logic board.
This battery is not a customer-replaceable part. Do not attempt to disassemble
it or recharge it.
Device Instances and Device Names
Installing SunFDDI/P Adapter Cards
Link Status Indicator (Diagnostic LED)
!