beautypg.com

Sun Microsystems 1.0 User Manual

Page 162

background image

136

SunFDDI/P 1.0 Adapter User’s GuideMay 1997

A

Can I use SunFDDI/P 1.0 in a redundant single-attached station (RSAS)
configuration?
No. This configuration, which was supported by SunFDDI 5.0 SBus,
provides a redundant connection that is used in the event of a link failure.
The equivalent configuration for SunFDDI/P 1.0 is provided by a dual-
attached station connected in dual-homing mode. See “Concentrators with
Dual-Homing” on page 74
for more information.

Can I use the SunFDDI/P 1.0 software with a hardware interface from a
third-party vendor?
No. The device driver does not support any third-party hardware products.

Can I connect two single-attached stations “back-to-back”, without
connecting them to a concentrator?
Yes. This configuration is supported by the FDDI specifications. You can also
connect two single-attached stations and one dual-attached station directly
in a ring, but this configuration is not supported by the FDDI specifications
and is not recommended.

What is dual-homing?
Dual-homing is a special configuration that connects a single dual-attached
station to two concentrators so that there is a redundant path, which is used
in the event of a link failure. See “Concentrators with Dual-Homing” on
page 74
for more information.

What is the MTBF for the various SunFDDI/P options?
The calculated mean time before fail (MTBF) for each of the SunFDDI/P
interface cards is 1231176 hours

This number was obtained using the standard method for calculating MTBF.

Why can’t I connect port A to port A, or port B to port B?
This type of configuration is forbidden by the FDDI specifications. It is
called “twisting” or “crossing” the ring. If you connect your FDDI station in
this configuration, the link status indicator will remain blinking green to
indicate an invalid connection. See Chapter 2, “Hardware Installation,” for a
description of the different diagnostic LEDs and Chapter 7, “FDDI Network
Topologies,”
for a description of the valid network configurations.