SUPER MICRO Computer P4SCT - Manual (Page 58)

S UPER P4SCT/P4SCT+/P4SCT+II User's Manual
4-6
ECC Configuration
This setting allows you to enable or disable ECC (Error Correction and
Checking). The options are "ECC" and "Non-ECC".
CSA LAN (Giga-LAN)
Select "Enabled" to activate the function of CSA LAN. The options are
"Enabled" and "Disabled".
Smart Fan Control
Select "Enabled" to enable the function of Smart Fan Control. The options
are "Disabled" and "Enabled".
On-Chip Serial ATA
This setting allows you to configure On-Chip Chipset Configurations. Select
"Disabled" to disable SATA controller. If "Auto" is selected, BIOS will
automatically configure the settings for SATA controller. Select "Combined
Mode" to combine the functionality of Parallel ATA (PATA) and Serial
ATA(SATA) (* with the maximum of two IDE drives available for each
channel.) If "Enhanced Mode" is selected, both SATA and PATA are
supported (*with the maximum of 6 IDE drives available.) If "SATA Only" is
selected, SATA will operate in the Legacy Mode. The options are Disabled,
Auto, Combined Mode, Enhanced Mode, and SATA only.
Serial ATA Port0/1 mode
This setting allows you to configure Serial ATA Port0/1 modes. The options
are Primary Master, Primary Slave, Secondary Master, Secondary Slave,
SATA0 Master and SATA1 Master.
SATA Mode
This setting allows you to set the SATA Mode RAID via BIOS. The options
are "RAID" and "IDE".
USB Controller
This setting allows you to enable or disable the USB Controller. The options
are Enabled, and Disabled.
USB 2.0 Controller
This setting allows you to enable or disable USB 2.0 (EHCI) Controller. The
options are Enabled, and Disabled.