Siemens HIPATH V1.2.33 - Manual (Page 69)

Parameters
69
System type
• Enter HiPath GK if the system environment is HiPath 5000.
• Enter Non-HiPath GK if you are using a third-party Æ Gatekeeper.
• Enter Æ Gateway if you are using a HiPath HG 1500.
• Enter Direct if you are using IP dialing and no Æ Gatekeeper.
• In optiPoint 410 standard/economy/entry HFA, you can choose be-
tween HiPath 4K V1.x, HiPath 4K V2.x and HiPath 3K V4.0.
Tag
Enter the required tag for the current alarm to be set in the Audio/Visual
Indications
tab.
Terminating line preference
Reserved for later use.
Time
• You should only mark this option if this information is not automatically
transmitted (for example by the
Æ PBX or an Æ DHCP server).
• If this option is marked, the computer’s system time is applied.
Time to live (minutes)
Use this function to specify the interval at which the telephone should
send a signal to the
Æ Gatekeeper (every time one third of the time set
elapses). If the "Time to live" value is set to three minutes, for example, the
telephone sends a signal every minute.
The highest value you can set is 4320 seconds, that is, three days.
Timezone offset
• You should only enter data here if an Æ SNTP server provides time in-
formation.
• The data describes the offset in hours compared to time information of
the SNTP server.
Tone_Duration
Enter the duration of the tone in seconds for the current alarm to be set in
the Audio/Visual Indications tab.