Siemens HIPATH V1.2.33 - Manual (Page 11)

Listing Connected IP Phones
11
Specifying the Number of Scans
You can specify the number of scans for a LAN-based scan or mark the
scan as continuous. Select the required option under Scan parameters.
You can select the maximum number of scans in the drop-down list or se-
lect "Continuous" for non-stop scanning.
There are two reasons for entering multiple scans:
1. An optiPoint is not fully installed or is in "Local mode" and is therefore
unable to answer while the scan is in progress.
2. The scan process uses the UDP protocol that does not guarantee to
forward the solicitation message or deliver a reply. Under these cir-
cumstances, multiple scans are more effective in certain network en-
vironments.
Hiding List Columns
You can hide and display columns before or after the scan. Click the View
drop-down menu on the menu bar and select or deselect the required op-
tion.
The MAC address option is not selected in this example so the column is
hidden.