Siemens HIPATH V1.2.33 - Manual (Page 64)

Parameters
64
PSTN acces code
Access code for the Æ PSTN telephone network.
QoS L2/L3
• The settings are based on the Æ QoS areas Æ Layer 2 and Æ Layer 3
that control the prioritization of transmitted data.
• Æ Layer 2 Priority and Virtual LAN ID (Æ VLAN ID) can be modified for
layer 2.
Æ Layer 3 Voice/Signaling can be modified for layer 3.
• The activation of Æ Layer 2 and/or Æ Layer 3 support is only recom-
mended if the Æ Switch used can interpret this information
(for example " Æ Layer 2 switch").
Realm
Display or change the SIP Realm value. SIP realm is used to identify the
phone at the SIP server.
Register by name
If this option is enabled and a terminal name is entered, this name will ap-
pear in the display in the second line on the left. The option is disabled by
default.
Registration LEDs
The LEDs illuminate when the telephone is activated. This indicates that
you have registered correctly. You can enable or disable this function with
on and off.
Registration Timer
Use this function to specify the amount of time required for logging on to
the SIP server again. Logging on again ensures that the SIP telephone re-
mains logged onto the SIP server. This enables you to also detect any serv-
er connection problems. The timer is preassigned the value 0 and can have
a maximum value of 72 minutes.
Ringer Melody
Select the Ringer Melody for the current alarm to be set in the Audio/Visual
Indications
tab. You can set the following values:
• silent or
• level 1 to 8
Ringer Sequence
Select the Ringer Sequence for the current alarm to be set in the Audio/
Visual Indications
tab. You can set the levels 1 to 3.