Siemens HIPATH V1.2.33 - Manual (Page 5)

Introduction
5
Introduction
The purpose of the Deployment Tool is to allow the administrator to re-
motely configure optiPoint IP phones en-mass.
The primary occasion when this will be done is when a set of new devices
is deployed for the first time. However, the tool may be used at any other
time as a means of configuring a group of phones with a consistent set of
data.
In general the Deployment Tool works on the principal that the same con-
figuration is delivered to each device, with the exception of the terminal
number (E.164 address). Every addressed device is assigned a separate
terminal number.
Supported Phones
• optiPoint 400 standard Release 3
• optiPoint 400 standard HFA Release 2
• optiPoint 400 standard SIP V2.3/V2.4/V3.0
• optiPoint 400 economy HFA
• optiPoint 410 entry HFA
• optiPoint 410 economy HFA
• optiPoint 410 standard HFA
• optiPoint 410 advance HFA
• optiPoint 600 office U
P0/E
• optiPoint 600 office HFA
• optiPoint 600 office SIP V2.3
• optiPoint 600 office SIP V2.4