Siemens HIPATH V1.2.33 - Manual (Page 20)

Configuration
20
Editing a Configuration
Call up the configuration of the selected optiPoint type. Before you can en-
ter a value in a field in the Setting column, you must mark the matching
option in the Parameter column. Values entered in the Setting column are
not sent to the devices if you did not mark the matching option in the Pa-
rameter column.
Switch to a different tab by clicking the required tab header. For information
on the tabs and parameters that you can process for a device type, see the
section on optiPoint types
Æ page 27 and the section on Tabs
Æ page 36.
Example:
Confirm the dialog with OK after entering the necessary parameter values
for this device type in all tabs (
Æ page 27).
Alternatively, you can use
•
Reset all to delete all values in the Setting column and at the same
time remove all markings in the Parameter column.
(Reset all applies to all tabs).
• Or quit the dialog with Cancel without applying the settings.