Siemens HIPATH V1.2.33 - Manual (Page 61)

Parameters
61
Layer 2 Priority
• You can only set this if Æ Layer 2 support is active (Æ QoS L2/L3).
• You can set a priority value between 0 and 7 for each of the 64 positions
here (priority 7: high, 0: low).
• This additional data transmission information is used for forwarding pri-
ority decisions when data arrives in a
Æ Switch.
LDAP Server Addr
Also known as "LDAP Directory Server IP address" or "Server address".
•
This can only be configured for optiPoint 600 office and optiPoint 410
standard/advance HFA.
• If you are using an Æ LDAP server, enter the Æ IP Address of this serv-
er here.
LDAP template name
• Enter the name of the LDAP template file that is used in connection
with the
Æ LDAP server.
• The file must be saved on the Æ FTP server in a specific directory
( Æ Download Server IP Address, Æ File path).
LDAP folder
Name of the directory on the Æ FTP server where you saved the Æ LDAP
file.
LDAP Server Port Number
• Also known as Port Number. This can only be configured for
optiPoint 600 office and optiPoint 410 standard/advance HFA.
• If you are using a Æ LDAP server, enter the Æ Port number here for
communication with this server.
• Possible values: 1 ... 65535.
Line Key action mode
Reserved for future function.
Location code
Enter the location code (the call number without extension number,
for example, of your company).
Location ID number
Contains the name or number saved for the phone on the server. This is
automatically entered in optiPoint and output on the display (also known as
local id). If a name is not available, the Location identifier number (LIN) is
output on the display.